Once a well has been drilled to total depth, evaluated, cased, and cemented, engineers complete it by inserting equipment, designed to optimize production, into the hole. The driver behind every well completion strategy, whether for a complex or basic well, is to recover as large a percentage of the original oil in place as possible.
The decision to case and cement a well for production or plug and abandon it as a dry hole relies heavily on formation evaluation (FE) using openhole logs.
Once FE log analysis indicates the existence and depth of formations likely to produce commercial volumes of hydrocarbons, steel casing is run in the borehole and cement is pumped behind it. Completion engineers then displace the drilling mud in the well with a completion fluid. This may be a clear fluid or brine formulated to be nonreactive with the formation.
A primary reason to cement casing is to prevent communication between producing zones, thus engineers run a cement bond log to ascertain that the cement sheath between the casing and the borehole wall is without flaws. If gaps exist, engineers remedy the problem by injecting cement through holes made in the casing at the appropriate depths. Engineers then perforate through the casing and cement sheath into sections of the formation where FE analysis indicates conditions are favorable for hydrocarbon flow.
“Defining Completion,” the fourth in a series of introductory articles by the Oilfield Review, provides a concise overview of the completions process.
Whether new to the industry or just looking to review the basics, this short article is a resource for understanding the fundamental concepts around completions in the E&P industry.
Download the “Defining Completion” article here.
Discover other introductory articles about concepts and technologies in the E&P industry at the Oilfield Review Web site.