Challenge: Reduce the volume of low-gravity solids in the oil-base drilling fluid without using wasteful, costly dilution methods.
Solution: Use RHE-USE two-stage centrifuge system to remove low-gravity solids during drilling.
During a drilling campaign in the Haynesville shale, an operator used the same mud on multiple wells. Over time, low-gravity solids accumulated in the fluid, eventually exceeding 10% of the mud volume. Because LGS can lead to tool failure, extra trips, and lower rate of penetration, drilling fluid specialists diluted the fluid with diesel and chemical additives. While effective, this continuous-dilution strategy resulted in higher mud volume, HSE risk, and drilling costs.
M-I SWACO recommended the RHE-USE two-stage centrifuge system as an economical, environmentally viable alternative to continuous dilution. Unlike conventional mechanical separation technologies, the RHE-USE system can extract ultrafine solids from oil-base drilling fluid. The RHE-USE system employs a mechanical and chemical process to remove solids as they enter the mud system, dramatically increasing plastic viscosity, drilling performance, and cleaning efficiency.
This innovative fluid processing system helped the operator treat and reuse 3,200 bbl of drilling fluid. The RHE-USE system maintained an average of 3.5% LGS content throughout the drilling process—a reduction of more than 65% compared with previous LGS content. In addition, the RHE-USE system reduced the rate of diesel dilution by nearly 50%, saving 1,300 bbl of diesel valued at USD 120,000. By minimizing dilution, the operator also eliminated costs associated with transportation, storing,
and reconditioning excess mud volume on location.
Download: Haynesville Operator Reduces Low-Gravity Solids by More Than 65%, Saving USD 120,000 (0.11 MB PDF)