ATC Automatic Tank-Cleaning Technology | Schlumberger

ATC

Automatic tank-cleaning technology

Decreased waste generation
Up to 90% less waste
Improved safety
Little or no confined-space entry
Reduced personnel required
Easy to operate with a small crew
Minimized downtime during cleaning process
Decreased cleaning time by 70%

Minimize HSE risks and decrease waste generation

Tanks on rigs and supply vessels must be cleaned as solids build up or fluids are changed to avoid cross-contamination. Until now, tank cleaning has typically involved laborers equipped with hoses, pressure washers, shovels, and squeegees.

ATC VAC technology at dock side
ATC LITE
Low-volume automatic tank-cleaning technology
Eliminate confined space entry requirements
Tank cleaning no longer has to be a slow, dirty, and labor intensive task that puts people in danger. See how ATC technology keeps your crews safe and reduces cost.
launch interactive
Offshore mobile
ATC technology
Offshore permanent
ATC LITE technology
Dock side
ATC VAC technology
Land operations
Xpress ATC technology

How it works

ATC technology employs tank-cleaning machines (TCMs) that are optimally positioned inside the tank. The machines are programmed based on the cleaning pattern and analysis of tank geometry. The portable ATC technology is brought onboard when the cleaning job is going to take place. The TCMs are connected to the ATC technology skid, which features pumps that send a mixture of surfactants and water to the TCMs.

Powerful water jets clean every surface inside the tank following the specially programmed cleaning pattern. A portable slop pump or rig-tank pumps transfer the slop back to a washwater recycling unit inside the ATC technology. There, the liquid phase is separated from the solids. Liquid is directed back to the TCMs for reuse as cleaning fluid until it becomes too contaminated by fine solids.

At the end of the operation, cleaning fluid and solid waste—predominantly barite—are safely removed from the installation or reused to build new mud volume. In cases where an overboard permit is in place, the process is simplified.

ATC technology also comprises customized cleaning chemistry for the specific mud type. The closed-loop system also reuses fluid by separating solids from the liquid. The 44 bbl of water and cleaning liquid prepared at the outset of the cleaning operation is used to clean several tanks. Once fine solids have settled out in the waste container, the liquid can be reused.

ATC automatic tank-cleaning technology
View All

Share This