Indonesia: KLA-SHIELD System Performs Similarly to an Invert Emulsion Mud Offshore East Kalimantan

Challenge: During planning of the 8 1/2-in. section in this directional well, the operator identified a number of technical challenges. These included the presence of reactive shale throughout the section and the high potential of encountering lost-circulation zones in the fractured carbonate of the lower deltaic sequence.

Solution: SLB recommended the KLA-SHIELD water-base drilling fluid system as opposed to a non-aqueous mud

Results: 

• Higher-than-expected ROP up to 160 ft/hr (49 m/hr)
• Good hole cleaning as per analysis by the VIRTUAL HYDRAULICS software

The Situation

During planning of the 8 ½-in. section in this directional well, the operator identified a number of technical challenges. These included the presence of reactive shale throughout the section and the high potential of encountering lost-circulation zones in the fractured carbonate of the lower deltaic sequence. With a high directional difficulty index (DDI) and maximum inclination of 60° increasing, hence the risk of high torque and drag, the operator planned to use a non-aqueous drilling fluid system in order to drill effectively to casing point within the cost and time frame established in the Authorization For Expenditure (AFE).

The Solution

SLB recommended the KLA-SHIELD water-base drilling fluid system as opposed to a non-aqueous mud. By employing the aqueous system, the operator was expected to stay within the programmed cost, while effectively drilling to casing point in the event of total lost circulation in this interval. The KLA-SHIELD system has been shown to deliver relatively low coefficients of friction (CoF) in similar well profiles while providing excellent shale inhibition. The proprietary VIRTUAL HYDRAULICS* program was used to predict and monitor hole cleaning during the entire interval.

The Results

• Higher-than-expected ROP up to 160 ft/hr (49 m/hr)
• Good hole cleaning as per analysis by the VIRTUAL HYDRAULICS software
• Drilling fluid cost was reduced significantly compared to the cost of an invert emulsion fluid. This was further magnified when experiencing mud losses of 30 – 40 bbl/hr.
• The overall CoF was less than 0.25 with the addition of STARGLIDE*and G-SEAL* PLUS additives.
• Drilled to casing point within AFE cost and time
• Completed formation evaluation, liner, and cement operation as programmed

The Details

As illustrated in the first chart below, the KLA-SHIELD system achieved a low coefficient of friction in the 8 ½- in. interval which improved its drilling performance. The system also delivered economic benefits as shown by the time vs. depth lines in the second chart.

Questions? We’ll be glad to answer them.

If you’d like to know more about the KLA-SHIELD system, and how it’s performing for our other customers, please call the SLB office nearest you.